Hi there,
So I tried installing Ubuntu Touch on the Nexus 6p by using UBports. I followed the instructions but I wiped all the Android data on there to assist me with rolling back the system if all would go pear shape as it did.
The short of it all I wiped everything and now I cant work out how to restore the NEX to stock when all the Android data is wiped.
I am using LINUX OS - POP. I am wanting to install TWRP etc via terminal but my NEX is not detected by the LINUX when in terminal.
I’ve tried adb devices, nothing comes up, its like it cant detect my E:\ phone connected and I am not able to enable usb debugging as the whole menu is wiped and the nex gets stuck in the loop.
Can I get some insights Android geniuses out there.
Gracias in advance.
2 Likes
Well my op 3t is still detected I’m running ubuntu touch on it ubuntu has a usb debugging mode also in setting but it only stays on for 10 minutes I think so double check in setting I for get where at I think you have the enabled developer options just the same as you do Android try that once but all you need is fast Boot and you can you can side load your factory firmware for your device
1 Like
You can also double check Ubuntu recovery and see what it says in the recovery I think it enables you to reflash your Android system double check those two and then get back to me I’ll be home from work in a few hours then I can help you more
1 Like
If all else fails you can use your factory firmware with Android flash tool you can try that
1 Like
As long as you have the Ubuntu touch on your phone in the Ubuntu touch settings there you should be able to enable USB debugging but it only stays on for a certain amount of time and then it shuts off
1 Like
You should still be able to put your phone in Edl mode which is volume up and volume down while plugging in the USB plug and that should put you in the Edl mode and once you’re in Edl mode you should be able to flash the factory firmware and Android fast tool
1 Like